When working with epoxy casting resins such as TECHNO CAST 8101 to produce thermoforming molds, it is important to open the container for part A and to mix the different additives throughout its mass using a drill and a mixer (jiffy mixer) in order to obtain a perfectly homogeneous part A.

If you don’t mix correctly or sufficiently, the system will lose effectiveness and the product may not polymerize since part A is too rich in resin.

Thus, the part A container should be opened and the bottom and sides scraped properly in order to obtain a completely homogeneous part A.

POLYMÈRES TECHNOLOGIES… Field experience is invaluable.

[email protected]

Leave a Reply

Your email address will not be published. Required fields are marked *